Numerical simulation of the thermo-stress-strain state of elements under 3D printing

Тип публікації :
Стаття
Дата випуску :
2021
Автор(и) :
Сенченков, І. К.
Юрженко, М. В.
Червінко, О. П.
Доля, О. В.
Мова основного тексту :
Англійська
eKNUTSHIR URL :
DOI :
Журнал :
Випуск :
4
ISSN :
1812-5409
Початкова сторінка :
70
Кінцева сторінка :
75
Цитування :
[APA 7] Сенченков, І. К., Юрженко, М. В., Червінко, О. П., & Доля, О. В. (2021). Numerical simulation of the thermo-stress-strain state of elements under 3D printing. Bulletin of Taras Shevchenko National University of Kyiv. Physics and Mathematics, (4), 70–75. https://doi.org/10.17721/1812-5409.2021/4.11
[ДСТУ] Numerical simulation of the thermo-stress-strain state of elements under 3D printing / І. К. Сенченков et al. Bulletin of Taras Shevchenko National University of Kyiv. Physics and Mathematics. 2021. no. 4. P. 70—75. DOI: 10.17721/1812-5409.2021/4.11 (date of access: 18.07.2026).
The paper is devoted to the assessment of the thermo-stress-strain state of elements of structures obtained by 3D printing using FDM (Fusing Deposition Modeling) technology. Three stages of solving this problem are considered: (1) - mathematical formulation of the problem, that includes universal balance relations, constitutive equations of mechanical behavior of the material and is based on the model of growing bodies; (2) the technique of finite-element solution with increasing mesh due to the addition of new elements; (3) - study of a specific problem of growing plate-like element by polymer PLA (polylactide) with temperature-dependent physical properties. Options of deposed layers of different thickness are considered. The residual stress-strain state of the body has a two-scale structure, which reflects the change of state characteristics in the scale of body size, as well as the thickness of the layers. As the thickness of the layers increases, the average values of the residual stresses decrease, but the amplitude of the stress fluctuations along the thickness of the layer slightly increase.
Pages of the article in the issue: 70 - 75
Language of the article: Ukrainian
Файл(и) :
Вантажиться...
Ескіз
Формат :

Adobe PDF

Розмір :

1.03 MB

Контрольна сума :

(MD5):89a800dfe76fbf86522fb328fcf85237

Creative Commons Attribution 4.0 International
Якщо не вказано інше, ця робота розповсюджується на умовах ліцензії Creative Commons Attribution 4.0 International